The short answer: A water source heat pump takes heat from a lake, river, pond, borehole or mine water and uses it to run your radiators and hot water. Under the Boiler Upgrade Scheme it counts as ground source, so you get £7,500 off in England and Wales, or £9,000 if you’re replacing oil or LPG with no mains gas (until 31 March 2027). The median ground source system cost £26,500 installed in 2025/26. Open-loop systems in England need an abstraction licence if they take more than 20 cubic metres of water a day.
Last verified: 20 November 2026 against Ofgem, GOV.UK and the Environment Agency.
Heated by oil or LPG? Your grant is £9,000, not £7,500, if you have no mains gas connection. It ends on 31 March 2027, and permits for an open loop can take time, so get a survey booked. See the £9,000 grant.
How a water source heat pump works
Water holds heat well, and a lake, river or aquifer stays at a steadier temperature through winter than the air does. A heat pump moves that low-grade heat up to a useful temperature for your home. There are two ways to collect it:
Closed loop
- Sealed pipes or coils sunk in the water carry a fluid that picks up heat
- No water leaves the source
- Abstraction licence (England): not needed
Open loop
- Water is pumped from a river, lake or borehole, through the heat pump, then returned
- Abstraction licence (England): needed over 20m³ a day
- Groundwater investigation consent before drilling; discharge permit or registered exemption
| Closed loop | Open loop | |
|---|---|---|
| How it works | Sealed pipes or coils sunk in the water carry a fluid that picks up heat. No water leaves the source. | Water is pumped from a river, lake or borehole, through the heat pump, then returned. |
| Typical water source | Lake, large pond, slow river | Borehole (groundwater), river, lake, mine water |
| Abstraction licence (England) | Not needed | Needed over 20m³ a day |
| Other permits | May need a permit or exemption for the discharge | Groundwater investigation consent before drilling; discharge permit or registered exemption |
| Upkeep | Low | Filters and pumps need checking |
What water do you need?
- A lake or large pond: the simplest route for a closed loop, if it’s deep and big enough not to freeze around the pipes.
- A river or stream: moving water renews the heat. Flow, flood risk and access matter.
- A borehole: groundwater from an open-loop borehole, or a standard closed-loop ground source borehole. Needs a geology check.
- Mine water: flooded old mine workings hold warm water in some former coalfield areas. Usually a bigger, shared scheme rather than a single home. Large sites tapping mine or river water are covered in industrial heat pumps.
The installer must design the system to the MCS standards and size it so it can heat the whole home. A specialist survey checks the water will supply enough heat on the coldest days.
Water source heat pump cost
The Boiler Upgrade Scheme reports water source heat pumps inside its ground source figures, so these are the closest official prices:
| System (2025/26, BUS-funded) | Median installed cost | Installs | After £7,500 | After £9,000 (oil/LPG) |
|---|---|---|---|---|
| Ground source (includes water source) | £26,500 | 365 | £19,000 | £17,500 |
| 8–10kW ground source | £21,541 | 60 | £14,041 | £12,541 |
| 12–14kW ground source | £25,750 | 97 | £18,250 | £16,750 |
| Shared ground loop heat pump | £26,301 | 12 | £18,801 | £17,301 |
Source: DESNZ BUS statistics, September 2026, Table A1.3A. Small samples, so a guide, not a quote.
What pushes the price up or down:
- Collector: a closed loop laid in a lake avoids drilling or digging long trenches, the biggest cost in most ground source jobs. An open loop borehole adds drilling and test pumping.
- Distance: the further the water is from the house, the more trenching and pipe.
- Permits and surveys: open loops need Environment Agency consents in England, and the charges are on top.
- Your home: heat loss, radiator upgrades and a hot water cylinder.
Heat pumps, including the groundworks for ground source, are zero-rated for VAT until 31 March 2027. For trench and borehole prices see ground source heat pump costs.
Permits: what the Environment Agency needs
This is where water source differs most from air or ground source. In England, the Environment Agency’s guidance (updated 19 November 2026) says for open-loop systems:
- Abstraction licence if you take more than 20 cubic metres a day from surface water or groundwater.
- Groundwater investigation consent before you drill or test pump any abstraction boreholes.
- Discharge: a permit, or a registered exemption if your system meets the conditions. For groundwater, a balanced system returning less than 430 cubic metres a day can be exempt. For surface water, there’s a position statement for small systems heating a single home that isn’t used for business.
Closed-loop systems need no groundwater consent or abstraction licence, but the Environment Agency says you may need an environmental permit for the discharge. Check the closed loop exemption conditions.
In Wales, the rules are run by Natural Resources Wales, so ask your installer to check with them. Fees and timings vary, so get the permit route in writing in your quote.
Efficiency: why water can beat air
A heat pump’s running cost depends on its seasonal efficiency (SCOP): units of heat out for each unit of electricity in. Because water stays warmer and steadier than winter air, a well-designed water source system can hold a higher SCOP in the cold months, when you need heat most. At the October to December 2026 price cap, a home needing about 10,200 kWh of heat would pay about £895 a year at SCOP 3.0, and about £767 at SCOP 3.5. See the workings in heat pump costs, and ask your installer for the design SCOP in writing.
Shared ground loops for terraces, flats and streets
A shared ground loop links two or more ground source heat pumps, on separate properties, to one loop. It can draw on boreholes or a water source. The rules:
- Each heat pump must serve one individual property.
- Each legally separate property can get its own grant, and shared ground loop heat pumps can get the £9,000 oil and LPG rate.
- Shared ground loop systems can be up to 300kWth in total.
- A single large heat pump heating several unrelated flats (a cascade) is not eligible.
Shared loops are still rare on the scheme, so ask who pays for and owns the shared boreholes or water collector.
When does water source beat air source?
| Water source | Air source | |
|---|---|---|
| Grant | £7,500 (£9,000 oil/LPG) | £7,500 (£9,000 oil/LPG) |
| Median installed cost (2025/26) | £26,500 (ground source figure) | £13,024 |
| Winter efficiency | Steadier, often higher | Drops in cold weather |
| Permits | Possible, especially open loop | Usually permitted development |
| Voucher window | 6 months | 3 months |
| Best for | Larger homes next to suitable water | Most homes |
Water source usually wins when the water is close to the house, the home has high heat demand, and a closed loop can avoid drilling. If not, air source with the same grant costs about half as much to install.
Funding-wise, Ofgem treats a water source system as ground source, so every rule in our Boiler Upgrade Scheme eligibility guide applies, and the full list of heat pump funding by nation is on our heat pump grants hub. In Scotland the Home Energy Scotland grant names water source heat pumps directly. Rural and no water to hand? A £5,000 biomass boiler grant is the other off-grid option. Whichever you choose, check the installer is MCS certified for that technology.
How to get the grant
- Check you qualify: you own the home in England or Wales, you’re replacing fossil fuel or electric heating, and you haven’t had government funding for a heat pump at the property.
- Get a survey from an MCS-certified installer experienced in water or ground source. Ask for the collector design, the permit route and the design SCOP.
- The installer applies on Ofgem’s system and takes £7,500 (or £9,000) off the quote. Ofgem contacts you to confirm.
- Install within 6 months, the voucher window for ground and water source.
- Spread the rest with a Warm Homes Loan of up to £35,000 total cost, some at 0%.
Scotland and Northern Ireland: the Boiler Upgrade Scheme is England and Wales only. In Scotland, Home Energy Scotland offers up to £7,500 grant plus an optional £7,500 interest-free loan for heat pumps. GOV.UK says Northern Ireland’s Boiler Replacement Scheme is closed.
Water source heat pumps: common questions
Can I get a grant for a water source heat pump?
Yes. Ofgem counts water source heat pumps as ground source heat pumps under the Boiler Upgrade Scheme, so the grant is £7,500 in England and Wales. If your home is heated by oil or LPG and has no mains gas connection, it’s £9,000 until 31 March 2027. There’s no income test.
How much does a water source heat pump cost?
The scheme reports water source installs inside its ground source figures. The median ground source heat pump paid in 2025/26 cost £26,500 installed, so about £19,000 after the £7,500 grant. A closed loop sunk in a lake can avoid the cost of drilling or trenching; an open loop borehole system adds drilling and permit costs. Get a site survey and quote.
Do I need a licence for a water source heat pump?
For an open-loop system in England, the Environment Agency says you need an abstraction licence if you take more than 20 cubic metres a day from surface water or groundwater, groundwater investigation consent before drilling or test pumping boreholes, and a discharge permit or registered exemption for the water you return. Closed loop systems need no abstraction licence, but may need a permit for the discharge. In Wales, check with Natural Resources Wales.
What’s the difference between open loop and closed loop?
A closed loop circulates a sealed fluid through pipes sunk in the water, so no water is taken out. An open loop pumps water from a river, lake or borehole through the heat pump and returns it, which is why it needs more permits.
Do I need a lake to have a water source heat pump?
No. Lakes, ponds and rivers work, but so can groundwater from a borehole, and in some areas flooded mine water. The water source has to be big enough, or flowing enough, to supply heat all winter, which a specialist survey will check.
Is a water source heat pump more efficient than air source?
It can be. Water holds a steadier temperature through winter than outdoor air, so a well-designed water source system often runs at a higher seasonal efficiency. Ask your installer for the design SCOP in writing.
Can flats or terraces share a water or ground source heat pump?
Yes, through a shared ground loop: two or more ground source heat pumps on separate properties connected to one loop, each heat pump serving its own home. Each eligible property can get its own grant, including the £9,000 oil and LPG rate. One large heat pump heating several flats isn’t eligible.
Is a water source heat pump worth it?
If you have a suitable water source close to the house, often yes: it can beat air source on efficiency and avoid the cost of a large trench or borehole field. If the water is far away, permits are complicated or the flow is low, an air source heat pump with the same £7,500 grant is usually cheaper.